Actuator Accessories

Our Products / Actuators & Accessories / Actuator Accessories
  • Eurotec Namur Throttle Plates for speed control (installed between solenoid valve & pneumatic actuator)

  • Eurotec’s Namur throttle plates are ideal for controlling the opening & closing speeds of pneumatic actuators. The key is to control the flow out of the actuator’s exhaust ports but there are two instances when this causes a problem. Firstly, if the actuator is fitted directly to a Namur style pilot solenoid valve, restricting the exhaust flow can put unwanted backpressure on the SV’s internals. This situation is even less effective when the actuator is a tiny one as the internal volume of the SV allows the actuator to fully stroke before the flow restriction has an effect.

    The Namur throttle plate solves both of these potential problems.
    Suitable for Double Acting (DPN52) and Spring Return (DPN32) Pneumatic Actuators

    Materials: anodised aluminium, NBR seals, 304SS screws (SS on request)
    Pressure: 0.5 – 10 bar



  • CLMA-N – Tube Fitting (Male Elbow)

  • Hylok model CLMA is a male elbow….used to join a fractional (⅛”, ¼” etc) stainless steel tube to a female NPT fitting. The data sheet list all of the options but the common fitting used for actuation assemblies is as follows:-

    CLMA 4-4N (¼” tube x ¼”male NPT thread)

    * Options: BSP connection (CLMA 4-4R); Brass fitting (CLMA 4-4N-BRAS)



  • CMC-N – Tube Fitting (Male Connector)

  • Hylok model CMC is a male connector….used to join a fractional (⅛”, ¼” etc) stainless steel tube to a female NPT fitting. The data sheet list all of the options but the common fitting used for actuation assemblies is as follows:-

    CMC 4-4N (¼” tube x ¼”male NPT thread)

    * Options: BSP connection (CMC 4-4R) Brass fitting (CMC 4-4N-BRAS)



  • Metalwork Push-in Air Line Fittings (Rotary Elbow)

  • Metalwork’s range of push-in fittings allows quick connection of air lines into pipes and actuators. It can be re-used thousands of times and the release bushing has patented screwdriver slots to facilitate release in applications not accessible to fingers.

    Material- nickel plated brass body, technopolymer release bushing, NBR seal

    Common sizes used for valve & actuator connection as follows:-
    For 6mm Hose
    2L39C08- 6mm hose x ⅛” male bsp
    2L39C09- 6mm hose x ¼” male bsp
    For 8mm Hose
    2L39C10- 8mm x ⅛” male bsp
    2L39C11- 8mm hose x ¼” male bsp



  • VSR Quick Exhaust Valve

  • Metalwork’s VSR Quick Exhaust Valve is used to evacuate air in a cylinder (actuator) quickly, increasing operating speed. Discharge rates at specific pressures shown in download sheet.

    Material: ⅛”→ ¼” Nickel plated body/cap, NBR seal, female BSP connection
    ½” Anodised aluminium, NBR seal, female BSP connection

    Common sizes used for valve / actuator connection as follows:-
    9101201 (VSR18) – ⅛” female bsp
    9201201 (VSR14) – ¼” female bsp
    9401201 (VSR12) – ½” female bsp