F-G1 Flanged Ball Valve + PA series Pneumatic Actuator
Actuated on/off flanged ball valves are available with pneumatic, hydraulic or electric actuation and a variety of control accessories.
Assemblies are built in house and function tested prior to despatch.
Click on the links above for further information on the components used.
Elite model BTE/BFE Solenoid Operated Control Valve
Elite model BTE/BFE uses a MFV (multi-function valve) as the main valve and is fitted with a Burkert 331-D 3/2-way solenoid valve as the pilot.
It is available in BTE threaded version 1½”→ 2” (Cv’s 48-75) and BFE flanged version in 2”-14” (Cv’s 75-3,000) and the choice of materials for the main valve are cast or ductile iron with bronze trim, bronze, 304ss or 316ss. Diaphragm and seat material can be either NBR or Viton and the pilot valve can be bronze or stainless steel. Flanged valves (2”-14”) can be drilled to suit Ansi 150# or AS Table D/E.
Maximum inlet pressure-1,000 kpa (145 psi)
Maximum temp- 80°C
Schubert & Salzer Ball Sector Control Valves
The Ball Sector Valve is specially designed to handle arduous duties, slurries and viscous fluids is suitable for control and isolation.
With pneumatic and electrical actuators, it is the best choice for very precise control in the paper, steel, chemical, food and effluent industries.
Sizes: DN25 (1″) up to DN300 (12″)
– High Kvs-values up to 3840
– Excellent control characteristics
– Suitable for abrasive media
– Easily exchangeable seat ring
– Low maintenance
– Actuators can be easily fitted
– Efficient and easy to install
Optional Volume booster Type 4090 (from DN150) in order to reduce the response time.
Model BTF/BFF Pilot Operated Float Valve
Elite model BTF/BFF uses a MFV (multi-function valve), which is supplied with model 2856 Float Valve as the pilot (shown above but not illustrated in the photo to the left). The valve is used for controlling the level of water in a tank. The main valve is usually piped directly into the base of the tank, allowing the pilot valve to be remotely fitted inside the tank.
It is available in BTF threaded version 1½”→ 2” (Cv’s 48-75) and BFF flanged version in 2”-14” (Cv’s 75-3,000) and the choice of materials for the main valve are cast or ductile iron with bronze trim, bronze, 304SS or 316SS. Diaphragm and seat material can be either NBR or Viton and the pilot valve can be 304SS/PE float or 316SS Ball/Float. Valve has either threaded ends (1½”→ 2”) or flanged ( ½”-6”) which can be drilled to suit Ansi 150# or AS Table D/E.
Note 1: A minimum water supply pressure of 30 kpa is recommended
Note 2: Actual WP must be advised so that the right diameter float is selected
Maximum inlet pressure- CI (12 Bar) BZ (16 Bar) DI (20 Bar) SS (25 Bar)
Min/Max Temp Range: -15°C → +80°C